Int. J. Simul. Multidisci. Des. Optim.
Volume 11, 2020
|Number of page(s)||8|
|Published online||22 October 2020|
Effect of face width of spur gear on bending stress using AGMA and ANSYS
Department of Mechanical Engg.,Amity University, Haryana, India
* e-mail: firstname.lastname@example.org
Accepted: 4 October 2020
In the present analysis, the effect of face width on the bending strength of spur gear has been studied. For this purpose face width of spur gear has been varied from 20 mm to 30 mm with a scale of 2 mm. Geometry of spur gear has been drawn using AutoCAD and the gear model has been simulated for bending stress using analysis software (ANSYS).Analytical equations (AGMA bending equations) have been used to find out analytical solution. Bending stress has been calculated at the gear tooth for different values of load. The simulation results have been compared with analytical solutions obtained using AGMA equations. It has been found from the results that increase in face width of spur gear results in decrease in bending stress and hence increase in bending strength.
Key words: Spur Gear / Auto CAD / ANSYS / Face Width / AGMA / Von-Mises Stress
© H. Singh and D. Kumar, published by EDP Sciences, 2020
This is an Open Access article distributed under the terms of the Creative Commons Attribution License (https://creativecommons.org/licenses/by/4.0), which permits unrestricted use, distribution, and reproduction in any medium, provided the original work is properly cited.
Current usage metrics show cumulative count of Article Views (full-text article views including HTML views, PDF and ePub downloads, according to the available data) and Abstracts Views on Vision4Press platform.
Data correspond to usage on the plateform after 2015. The current usage metrics is available 48-96 hours after online publication and is updated daily on week days.
Initial download of the metrics may take a while.